summaryrefslogtreecommitdiff
path: root/src
Commit message (Expand)AuthorAge
* altos: Add full MM telemetryKeith Packard2012-06-21
* altos: Configure STM LCD driver for giant LCD digitsKeith Packard2012-06-21
* altos: Make sure ao_storage_config is set before reading config blockKeith Packard2012-06-17
* altos: hack STM serial number to 58Keith Packard2012-06-17
* altos: make cc1120 ao_radio_send re-entrantKeith Packard2012-06-17
* altos: Add telemetry to megametrumKeith Packard2012-06-17
* altos: Software implemenation of CC1111 radio encodingKeith Packard2012-06-17
* altos: Be more careful about register save/restore in ao_yieldKeith Packard2012-06-17
* altos: Don't lose IRQ disabled state in ao_sleepKeith Packard2012-06-17
* altos: ao_storage_read already calls ao_storage_setupKeith Packard2012-06-17
* altos: Use interrupts to wake up after RDF transmission.Keith Packard2012-06-17
* altos: Crank cc1120 power down to 0dBm to avoid crashing CPUKeith Packard2012-06-17
* altos: Reduce STM SPI data rate to 4MHzKeith Packard2012-06-15
* altos: Start making cc1120 radio workKeith Packard2012-06-15
* altos: Fix cc1120 packet mode datarate and configKeith Packard2012-06-15
* altos: Make sure cc1120 is initialized correctly at startup timeKeith Packard2012-06-15
* altos: use 'b' command for radio beepKeith Packard2012-06-15
* altos: Fix RDF mode data rate and PKT_CFG0 valueKeith Packard2012-06-15
* altos: Actually write cc1120 register valuesKeith Packard2012-06-15
* altos: Configure cc1120 frequencyKeith Packard2012-06-15
* Temporarily disable packet and telem on MMKeith Packard2012-06-15
* Allow product to override maximum number of command lists (NUM_CMDS)Keith Packard2012-06-15
* altos: Make cc1111 products all depend on ao_arch.h and ao_arch_func.hKeith Packard2012-06-04
* altos: Other half of the ms5607 prom reporting patchKeith Packard2012-06-04
* altos: typo in ao_monitor prevented ground station from including codeKeith Packard2012-06-04
* altos: Make 'v' command dump pressure sensor ROM valuesKeith Packard2012-06-04
* altos: fix test builds of non-accel flight codeKeith Packard2012-06-04
* altos: Legacy telemetry needs original ADC recordKeith Packard2012-06-04
* altos: Remove unused AES code from teledongle and tidongleKeith Packard2012-06-04
* altos: Remove accel_ref from pre v1.1 TM firmwareKeith Packard2012-06-04
* altos: Intgrate hmc5883 sensor into adc ringKeith Packard2012-06-02
* altos: Get HMC5883 driver limping alongKeith Packard2012-06-02
* altos: Reset i2c controller at boot timeKeith Packard2012-06-02
* altos: Fix broken EXTI edge mode selections. Clear pending exti on enableKeith Packard2012-06-02
* altos: Route correct GPIO line to interrupt controllerKeith Packard2012-06-02
* altos: Enable some debugging during flight mode on MMKeith Packard2012-06-02
* altos: Add support for MegaAccel daughter card.Keith Packard2012-06-01
* altos: Timers clock base depends on perhipheral bus prescalers tooKeith Packard2012-06-01
* altos: megametrum has loggingKeith Packard2012-06-01
* altos: add high-z accel and mag sensor to megametrum loggingKeith Packard2012-06-01
* altos: Mark full and mega logging correctly in 'v' commandKeith Packard2012-06-01
* altos: Clear stm i2c transfer timeout alarmKeith Packard2012-05-28
* altos: Remove debug printf from accel auto-calKeith Packard2012-05-28
* altos: Clean up ADC selection for cc1111Keith Packard2012-05-28
* altos: All cc1111 products have a radioKeith Packard2012-05-28
* altos: Shrink telemetry generation codeKeith Packard2012-05-28
* altos: Try to get hmc5883 workingKeith Packard2012-05-28
* altos: Make teleterra v0.2 compile with new ao_data structKeith Packard2012-05-27
* altos: Make telepyro-v0.1 build with new ao_data structKeith Packard2012-05-27
* altos: Make telescience-v0.1 build with new ao_data structKeith Packard2012-05-27