mjb/altos - AltOS - the operating system for Altus Metrum products

	Commit message (Collapse)	Author	Age
*	altos: No need to initialize EXTI priorities at startup time	Keith Packard	2012-08-28
\| \| \| \| \| \|	They all get set to the correct value when enabled. Signed-off-by: Keith Packard <keithp@keithp.com>
*	altos: Add ao_gpio_get and ao_exti_set_mode	Keith Packard	2012-08-06
\| \| \| \| \| \|	Needed to support general GPIO interrupts Signed-off-by: Keith Packard <keithp@keithp.com>
*	altos: Optimize FEC encode and decode	Keith Packard	2012-06-26
\| \| \| \| \| \| \| \| \| \| \| \| \|	Integrate interleaving, CRC and padding within the decode/encode functions. Provide for ISR priorities so that the 1120 RX interrupt takes precedence over the other interrupts or we risk losing bits. Optimize the viterbi decoder a bit (goes from 10ms per packet to 7ms per packet). Signed-off-by: Keith Packard <keithp@keithp.com>
*	altos: Get cc1120 packet reception working	Keith Packard	2012-06-25
\| \| \| \| \| \|	Interrupt-per-bit, but it seems to work Signed-off-by: Keith Packard <keithp@keithp.com>
*	altos: Fix broken EXTI edge mode selections. Clear pending exti on enable	Keith Packard	2012-06-02
\| \| \| \| \| \| \| \| \|	Make sure the edge mode registers are set according to the requested mode. Clear any pending interrupt when enabling to avoid spurious isr call Signed-off-by: Keith Packard <keithp@keithp.com>
*	altos: Route correct GPIO line to interrupt controller	Keith Packard	2012-06-02
\| \| \| \| \| \| \|	Which GPIO a particular pin interrupt comes from is selected by the SYSCFG EXTICR registers; set these when an exti interrupt is configured. Signed-off-by: Keith Packard <keithp@keithp.com>
*	altos: Starting to write cc1120 driver	Keith Packard	2012-04-17
	This does "something" in radio test mode, appearing to generate a 730MHz signal. Signed-off-by: Keith Packard <keithp@keithp.com>