summaryrefslogtreecommitdiff
path: root/doc
Commit message (Collapse)AuthorAge
* altos: Note that Lithium battery may be included with MicroPeakmicropeak-1.1Keith Packard2012-12-12
| | | | | | | | I'm not willing to say that we'll always be able to include a battery, but we can certainly try, and they're certainly cheap enough that we should. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Update MicroPeak doc to include EEPROM and programming infoKeith Packard2012-12-12
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Minor updates to the micropeak docsKeith Packard2012-11-18
| | | | | | | Mention light issue in quick start guide. Update run-time estimate to 40 hours (measured over 44 hours) Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Start updating AltOS documentation for multi-archKeith Packard2012-11-16
| | | | | | | Now that AltOS supports many processors, start updating the documentation to match. Signed-off-by: Keith Packard <keithp@keithp.com>
* altos/micropeak: Set boost detect to 10m. Add 30s boost delay.Keith Packard2012-10-29
| | | | | | | | | | | Wait for 30 seconds before even starting look for boost. This provides an opportunity to close up the airframe, potentially causing pressure gradients seen by the baro sensor. Also, require a 10m vertical motion before triggering boost. This should limit accidental boost detect while capturing any actual flights. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Add micropeak manualKeith Packard2012-10-29
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* Add release notes for version 1.1.1Keith Packard2012-09-16
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Add revision history for 1.1. Update copyright dateKeith Packard2012-09-13
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Document imperial units and groundstation configurationKeith Packard2012-09-13
| | | | | | What it says on the tin. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Mention changes to flight data download UIKeith Packard2012-09-12
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* Add Version 1.1 release notes.Keith Packard2012-09-11
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* Add megametrum outline to doc dirKeith Packard2012-07-11
| | | | | | And install it alongside telemetrum-outline Signed-off-by: Keith Packard <keithp@keithp.com>
* be explicit in a couple places about only using single-cell LiPo batteriesBdale Garbee2012-03-31
|
* doc: Add companion SPI message protocol docKeith Packard2012-01-15
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* altos: Create TeleMetrum v1.2 directoryKeith Packard2011-12-17
| | | | | | | The hardware is software-compatible with v1.1, but it's nice to have the right version number in all of the files. Signed-off-by: Keith Packard <keithp@keithp.com>
* include 1.0.1 release notes in docs, closes: #642705Bdale Garbee2011-09-24
|
* roll release notes version from 1.0 to 1.0.1Bdale Garbee2011-08-26
|
* Merge branch 'master' of ssh://git.gag.com/scm/git/fw/altosBdale Garbee2011-08-25
|\ | | | | | | | | Conflicts: doc/altusmetrum.xsl
| * doc: Remove duplicate documentation about max flight logKeith Packard2011-08-24
| | | | | | | | | | | | | | This was described in detail in both the System Operation and AltosUI chapters. Remove the duplicate from the AltosUI chapter. Signed-off-by: Keith Packard <keithp@keithp.com>
| * Merge remote-tracking branch 'origin/master'Keith Packard2011-08-24
| |\
| * | doc: Describe max flight log, ignite mode and pad orientationKeith Packard2011-08-24
| | | | | | | | | | | | | | | | | | These describe what these configuration parmaeters do, not how to set them. Signed-off-by: Keith Packard <keithp@keithp.com>
* | | more tweaksBdale Garbee2011-08-25
| |/ |/|
* | Merge branch 'master' of ssh://git.gag.com/scm/git/fw/altosBdale Garbee2011-08-24
|\| | | | | | | | | Conflicts: doc/altusmetrum.xsl
| * doc: Move the remaining command-mode descriptions to the appendixKeith Packard2011-08-24
| | | | | | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* | tweak tweak tweakBdale Garbee2011-08-24
|/
* Merge branch 'master' of ssh://git.gag.com/scm/git/fw/altosBdale Garbee2011-08-24
|\
| * doc: Updating Firmware is now a separate chapterKeith Packard2011-08-24
| | | | | | | | | | | | The Flash Image paragraph references it, change the reference wording. Signed-off-by: Keith Packard <keithp@keithp.com>
| * doc: Move updating device firmware section to separate chapterKeith Packard2011-08-24
| | | | | | | | | | | | | | This isn't central to operation of the devices, so move it out to a separate chapter Signed-off-by: Keith Packard <keithp@keithp.com>
* | more changesBdale Garbee2011-08-24
|/
* Merge branch 'master' of ssh://git.gag.com/scm/git/fw/altosBdale Garbee2011-08-24
|\
| * doc: use 'radio link' to refer to packet command modeKeith Packard2011-08-24
| | | | | | | | | | | | | | Make sure 'radio link' doesn't refer to telemetry and eliminate use of 'RF link' and other similar but not identical phrases. Signed-off-by: Keith Packard <keithp@keithp.com>
* | more tweakingBdale Garbee2011-08-24
|/
* more tweaksBdale Garbee2011-08-24
|
* Merge branch 'master' of ssh://git.gag.com/scm/git/fw/altosBdale Garbee2011-08-24
|\
| * doc: Move Packet Command Mode section to System Operations chapterKeith Packard2011-08-24
| | | | | | | | | | | | It makes far more sense here. Signed-off-by: Keith Packard <keithp@keithp.com>
| * doc: Describe packet command mode a bit better.Keith Packard2011-08-24
| | | | | | | | | | | | | | | | Include comments about TeleMini in the introduction, and then explain a bit better what the best method of reliably initiating packet command mode are (start operation, then boot telemini). Signed-off-by: Keith Packard <keithp@keithp.com>
* | more doc tweaksBdale Garbee2011-08-24
|/
* more doc tweakingBdale Garbee2011-08-24
|
* doc: Document pad-mode 'on-board data logging' indicatorKeith Packard2011-08-24
| | | | | | There wasn't any documentation for this field in the 'Launch Pad' tab. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Spelling corrections in altusmetrum.xslKeith Packard2011-08-24
| | | | | | Lots of minor spelling errors. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc tweaks through chap 3Bdale Garbee2011-08-24
|
* altosui: Make flight monitor font size configurableKeith Packard2011-08-24
| | | | | | | Tiny netbooks aren't tall enough for the 'usual' font size, so provide a smaller option. Then provide a bigger option, just because. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Add Installation Recommendations chapterKeith Packard2011-08-22
| | | | | | | Document installation suggestions, including mounting, RFI, antenna issues and ground testing. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Add note about telemetry disable mode to 1.0 release notesKeith Packard2011-08-22
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Add 1.0 release notes.Keith Packard2011-08-10
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Add release notes, include them in altusmetrum doc. Shuffle altusmetrumKeith Packard2011-08-10
| | | | | | | This adds release notes and includes them in the main altusmetrum doc as well as making stand-alone html available for inclusion in the website. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Describe 'stats' tab in Graph UI, 'Graph Flight' button.Keith Packard2011-08-10
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Document Ignite Mode and Pad Orientation configuration optionsKeith Packard2011-08-10
| | | | Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Update altusmetrum.xsl for v1.0 software and TeleMiniKeith Packard2011-08-10
| | | | | | | Add TeleMini references and sections as appropriate, update AltosUI docs to describe new bits. Signed-off-by: Keith Packard <keithp@keithp.com>
* doc: Add section about TeleDongle USB line formatKeith Packard2011-07-05
| | | | | | | Describe the format of the TELEM lines sent over USB from TeleDongle to the host. Signed-off-by: Keith Packard <keithp@keithp.com>
generated by cgit v1.2.3 (git 2.39.1) at 2025-12-27 00:44:08 +0000