diff options
Diffstat (limited to 'src/stm/ao_arch_funcs.h')
| -rw-r--r-- | src/stm/ao_arch_funcs.h | 177 |
1 files changed, 172 insertions, 5 deletions
diff --git a/src/stm/ao_arch_funcs.h b/src/stm/ao_arch_funcs.h index d4fbea37..1e78cabc 100644 --- a/src/stm/ao_arch_funcs.h +++ b/src/stm/ao_arch_funcs.h @@ -21,9 +21,22 @@ /* ao_spi_stm.c */ -#define AO_SPI_SPEED_FAST STM_SPI_CR1_BR_PCLK_4 +/* PCLK is set to 16MHz (HCLK 32MHz, APB prescaler 2) */ + +#define AO_SPI_SPEED_8MHz STM_SPI_CR1_BR_PCLK_2 +#define AO_SPI_SPEED_4MHz STM_SPI_CR1_BR_PCLK_4 +#define AO_SPI_SPEED_2MHz STM_SPI_CR1_BR_PCLK_8 #define AO_SPI_SPEED_1MHz STM_SPI_CR1_BR_PCLK_16 -#define AO_SPI_SPEED_200kHz STM_SPI_CR1_BR_PCLK_256 +#define AO_SPI_SPEED_500kHz STM_SPI_CR1_BR_PCLK_32 +#define AO_SPI_SPEED_250kHz STM_SPI_CR1_BR_PCLK_64 +#define AO_SPI_SPEED_125kHz STM_SPI_CR1_BR_PCLK_128 +#define AO_SPI_SPEED_62500Hz STM_SPI_CR1_BR_PCLK_256 + +#define AO_SPI_SPEED_FAST AO_SPI_SPEED_8MHz + +/* Companion bus wants something no faster than 200kHz */ + +#define AO_SPI_SPEED_200kHz AO_SPI_SPEED_125kHz #define AO_SPI_CONFIG_1 0x00 #define AO_SPI_1_CONFIG_PA5_PA6_PA7 AO_SPI_CONFIG_1 @@ -100,6 +113,19 @@ ao_spi_init(void); stm_rcc.ahbenr |= (1 << STM_RCC_AHBENR_GPIOEEN); \ } while (0) +#define ao_disable_port(port) do { \ + if ((port) == &stm_gpioa) \ + stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOAEN); \ + else if ((port) == &stm_gpiob) \ + stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOBEN); \ + else if ((port) == &stm_gpioc) \ + stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOCEN); \ + else if ((port) == &stm_gpiod) \ + stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIODEN); \ + else if ((port) == &stm_gpioe) \ + stm_rcc.ahbenr &= ~(1 << STM_RCC_AHBENR_GPIOEEN); \ + } while (0) + #define ao_gpio_set(port, bit, pin, v) stm_gpio_set(port, bit, v) @@ -111,9 +137,7 @@ ao_spi_init(void); stm_moder_set(port, bit, STM_MODER_OUTPUT);\ } while (0) -#define ao_enable_input(port,bit,mode) do { \ - ao_enable_port(port); \ - stm_moder_set(port, bit, STM_MODER_INPUT); \ +#define ao_gpio_set_mode(port,bit,mode) do { \ if (mode == AO_EXTI_MODE_PULL_UP) \ stm_pupdr_set(port, bit, STM_PUPDR_PULL_UP); \ else if (mode == AO_EXTI_MODE_PULL_DOWN) \ @@ -121,6 +145,12 @@ ao_spi_init(void); else \ stm_pupdr_set(port, bit, STM_PUPDR_NONE); \ } while (0) + +#define ao_enable_input(port,bit,mode) do { \ + ao_enable_port(port); \ + stm_moder_set(port, bit, STM_MODER_INPUT); \ + ao_gpio_set_mode(port, bit, mode); \ + } while (0) #define ao_enable_cs(port,bit) do { \ stm_gpio_set((port), bit, 1); \ @@ -197,4 +227,141 @@ ao_i2c_recv(void *block, uint16_t len, uint8_t i2c_index, uint8_t stop); void ao_i2c_init(void); +/* ao_serial_stm.c */ +struct ao_stm_usart { + struct ao_fifo rx_fifo; + struct ao_fifo tx_fifo; + struct stm_usart *reg; + uint8_t tx_started; +}; + +#if HAS_SERIAL_1 +extern struct ao_stm_usart ao_stm_usart1; +#endif + +#if HAS_SERIAL_2 +extern struct ao_stm_usart ao_stm_usart2; +#endif + +#if HAS_SERIAL_3 +extern struct ao_stm_usart ao_stm_usart3; +#endif + +#define ARM_PUSH32(stack, val) (*(--(stack)) = (val)) + +static inline uint32_t +ao_arch_irqsave(void) { + uint32_t primask; + asm("mrs %0,primask" : "=&r" (primask)); + ao_arch_block_interrupts(); + return primask; +} + +static inline void +ao_arch_irqrestore(uint32_t primask) { + asm("msr primask,%0" : : "r" (primask)); +} + +static inline void +ao_arch_memory_barrier() { + asm volatile("" ::: "memory"); +} + +#if HAS_TASK +static inline void +ao_arch_init_stack(struct ao_task *task, void *start) +{ + uint32_t *sp = (uint32_t *) (task->stack + AO_STACK_SIZE); + uint32_t a = (uint32_t) start; + int i; + + /* Return address (goes into LR) */ + ARM_PUSH32(sp, a); + + /* Clear register values r0-r12 */ + i = 13; + while (i--) + ARM_PUSH32(sp, 0); + + /* APSR */ + ARM_PUSH32(sp, 0); + + /* PRIMASK with interrupts enabled */ + ARM_PUSH32(sp, 0); + + task->sp = sp; +} + +static inline void ao_arch_save_regs(void) { + /* Save general registers */ + asm("push {r0-r12,lr}\n"); + + /* Save APSR */ + asm("mrs r0,apsr"); + asm("push {r0}"); + + /* Save PRIMASK */ + asm("mrs r0,primask"); + asm("push {r0}"); +} + +static inline void ao_arch_save_stack(void) { + uint32_t *sp; + asm("mov %0,sp" : "=&r" (sp) ); + ao_cur_task->sp = (sp); + if ((uint8_t *) sp < &ao_cur_task->stack[0]) + ao_panic (AO_PANIC_STACK); +} + +static inline void ao_arch_restore_stack(void) { + uint32_t sp; + sp = (uint32_t) ao_cur_task->sp; + + /* Switch stacks */ + asm("mov sp, %0" : : "r" (sp) ); + + /* Restore PRIMASK */ + asm("pop {r0}"); + asm("msr primask,r0"); + + /* Restore APSR */ + asm("pop {r0}"); + asm("msr apsr,r0"); + + /* Restore general registers */ + asm("pop {r0-r12,lr}\n"); + + /* Return to calling function */ + asm("bx lr"); +} + +#define HAS_ARCH_START_SCHEDULER 1 + +static inline void ao_arch_start_scheduler(void) { + uint32_t sp; + uint32_t control; + + asm("mrs %0,msp" : "=&r" (sp)); + asm("msr psp,%0" : : "r" (sp)); + asm("mrs %0,control" : "=&r" (control)); + control |= (1 << 1); + asm("msr control,%0" : : "r" (control)); +} + +#define ao_arch_isr_stack() + +#endif + +#define ao_arch_wait_interrupt() do { \ + asm(".global ao_idle_loc\n\twfi\nao_idle_loc:"); \ + ao_arch_release_interrupts(); \ + ao_arch_block_interrupts(); \ + } while (0) + +#define ao_arch_critical(b) do { \ + ao_arch_block_interrupts(); \ + do { b } while (0); \ + ao_arch_release_interrupts(); \ + } while (0) + #endif /* _AO_ARCH_FUNCS_H_ */ |