1 files changed, 81 insertions, 0 deletions
diff --git a/doc/telegps-using.inc b/doc/telegps-using.inc
new file mode 100644
index 00000000..1dd889cd
--- /dev/null
+++ b/doc/telegps-using.inc
@@ -0,0 +1,81 @@
+== Using TeleGPS Hardware
+
+	=== Hooking Up Lithium Polymer Batteries
+
+		TeleGPS has a two pin JST PH series connector to connect up
+		a single-cell Lithium Polymer cell (3.7V nominal). You can
+		purchase matching batteries from the Altus Metrum store, or
+		other vendors, or you can make your own. Pin 1 of the
+		connector is positive, pin 2 is negative. Spark Fun sells a
+		cable with the connector attached, which they call a
+		link:https://www.sparkfun.com/products/9914[JST Jumper 2 Wire Assembly]
+
+
+		[WARNING]
+		Many RC vendors also sell lithium polymer batteries with
+		this same connector. All that we have found use the opposite
+		polarity, and if you use them that way, you will damage or
+		destroy TeleGPS.
+
+	=== On-board Data Recording
+
+		TeleGPS logs GPS data at a user-configurable
+		rate. Data are logged to a 2MB on-board flash memory
+		part, which can be partitioned into several
+		equal-sized blocks, one for each flight. 64kB of this
+		storage are reserved to hold configuration data,
+		leaving 1984kB for flight data.
+
+		The on-board flash is partitioned into separate flight
+		logs, each of a fixed maximum size. Increase the
+		maximum size of each log and you reduce the number of
+		flights that can be stored. Decrease the size and you
+		can store more flights.
+
+		To compute the amount of space needed for a single
+		log, you can divide the expected time (in seconds) by
+		the sample period (by default, 1 second per sample)
+		and then multiply the result by 32 bytes per
+		sample. For instance, a sample period of 1 second and
+		a flight lasting one hour will take 32 * 3600 = 115200
+		bytes. TeleGPS does try to reduce log space used by
+		not recording position information when it isn't
+		moving, so actual space consumed may be less than
+		this.
+
+		The default size allows for four flights of 496kB
+		each, which provides over four hours of logging at 1
+		sample per second.
+
+		TeleGPS will not overwrite existing flight data, so be
+		sure to download flight data and erase it from the
+		onboard flash before it fills up. TeleGPS will still
+		report telemetry even if memory is full, so the only
+		thing you will lose is the on-board data log.
+      
+	=== Installation
+
+		The battery connectors are a standard 2-pin JST
+		connector and match batteries sold by Spark Fun. These
+		batteries are single-cell Lithium Polymer batteries
+		that nominally provide 3.7 volts.  Other vendors sell
+		similar batteries for RC aircraft using mating
+		connectors, however the polarity for those is
+		generally reversed from the batteries used by Altus
+		Metrum products. In particular, the Tenergy batteries
+		supplied for use in Featherweight flight computers are
+		not compatible with Altus Metrum flight computers or
+		battery chargers.
+
+		[WARNING]
+		Check polarity and voltage before connecting any
+		battery not purchased from Altus Metrum or Spark
+		Fun.
+
+		TeleGPS uses an integrate GPS patch antenna and won't
+		receive GPS signals if installed inside a metal or
+		carbon fiber compartment. Test GPS reception and
+		telemetry transmission with the system installed and
+		all other electronics powered up to verify signal
+		reception and make sure there isn't any interference
+		from other systems.