diff options
Diffstat (limited to 'doc/altusmetrum.xsl')
| -rw-r--r-- | doc/altusmetrum.xsl | 20 |
1 files changed, 13 insertions, 7 deletions
diff --git a/doc/altusmetrum.xsl b/doc/altusmetrum.xsl index af892e0f..231371c7 100644 --- a/doc/altusmetrum.xsl +++ b/doc/altusmetrum.xsl @@ -1106,12 +1106,13 @@ NAR #88757, TRA #12200 afar, as if it were directly connected to the computer. </para> <para> - Any operation which can be performed with TeleMetrum - can either be done with TeleMetrum directly connected to - the computer via the USB cable, or through the packet - link. Simply select the appropriate TeleDongle device when - the list of devices is presented and AltosUI will use packet - command mode. + Any operation which can be performed with TeleMetrum can + either be done with TeleMetrum directly connected to the + computer via the USB cable, or through the packet + link. TeleMini doesn't provide a USB connector and so it can + only be controlled through the packet link. Select the + appropriate TeleDongle device when the list of devices is + presented and AltosUI will use packet command mode. </para> <para> One oddity in the current interface is how AltosUI selects the @@ -1170,7 +1171,12 @@ NAR #88757, TRA #12200 TeleMini listens for a command packet for five seconds after first being turned on, if it doesn't hear anything, it enters 'pad' mode, ready for flight and will no longer listen for - command packets. + command packets. The easiest way to connect to TeleMini is to + initiate the command and select the TeleDongle device. At this + point, the TeleDongle will be attempting to communicate with + the TeleMini. Now turn TeleMini on, and it should immediately + start communicating with the TeleDongle and the desired + operation can be performed. </para> <para> When packet command mode is enabled, you can monitor the link |