diff options
Diffstat (limited to 'doc/altusmetrum.xsl')
| -rw-r--r-- | doc/altusmetrum.xsl | 32 |
1 files changed, 24 insertions, 8 deletions
diff --git a/doc/altusmetrum.xsl b/doc/altusmetrum.xsl index 431e43e6..a6d2ff12 100644 --- a/doc/altusmetrum.xsl +++ b/doc/altusmetrum.xsl @@ -36,6 +36,14 @@ </legalnotice> <revhistory> <revision> + <revnumber>1.3.1</revnumber> + <date>21 January 2014</date> + <revremark> + Bug fixes for TeleMega and TeleMetrum v2.0 along with a few + small UI improvements. + </revremark> + </revision> + <revision> <revnumber>1.3</revnumber> <date>12 November 2013</date> <revremark> @@ -1787,10 +1795,10 @@ NAR #88757, TRA #12200 rocket as it heads towards apogee. </para> <para> - The height, speed and acceleration are shown along with the - maximum values for each of them. This allows you to quickly - answer the most commonly asked questions you'll hear during - flight. + The height, speed, acceleration and tilt are shown along + with the maximum values for each of them. This allows you to + quickly answer the most commonly asked questions you'll hear + during flight. </para> <para> The current latitude and longitude reported by the GPS are @@ -2598,8 +2606,8 @@ NAR #88757, TRA #12200 <para> Selecting the 'Fire Igniter' button brings up the usual device selection dialog. Pick the desired device. This brings up another - window which shows the current continuity test status for both - apogee and main charges. + window which shows the current continuity test status for all + of the pyro channels. </para> <para> Next, select the desired igniter to fire. This will enable the @@ -4186,11 +4194,12 @@ NAR #88757, TRA #12200 Then, divide 434.550 MHz by the measured frequency and multiply by the current radio cal value show in the 'c s' command. For an unprogrammed board, the default value - is 1186611. Take the resulting integer and program it using the 'c f' + is 1186611 for cc1111 based products and 7119667 for cc1120 + based products. Take the resulting integer and program it using the 'c f' command. Testing with the 'C' command again should show a carrier within a few tens of Hertz of the intended frequency. As with all 'c' sub-commands, follow this with a 'c w' to write the - change to the parameter block in the on-board DataFlash chip. + change to the configuration memory. </para> <para> Note that the 'reboot' command, which is very useful on the altimeters, @@ -4448,6 +4457,13 @@ NAR #88757, TRA #12200 <appendix> <title>Release Notes</title> <simplesect> + <title>Version 1.3.1</title> + <xi:include + xmlns:xi="http://www.w3.org/2001/XInclude" + href="release-notes-1.3.1.xsl" + xpointer="xpointer(/article/*)"/> + </simplesect> + <simplesect> <title>Version 1.3</title> <xi:include xmlns:xi="http://www.w3.org/2001/XInclude" |