mjb/altos/src, branch 0.9.3

altos: Make telescience reliably log only when told to

2011-05-24T21:10:01+00:00

Use a pull-up on telescience and tri-state input on telemetrum at boot time. Enable logging by pulling the TM output low and enabling as an output, disable by pulling the TM output high and switching back to input mode. Also, ignore pin state changes for 5 seconds at boot to give things a chance to settle down. Should work when both boards are powered up together. Signed-off-by: Keith Packard

altos: Signal ascent using P1_2 (0 = ascent, 1 = other)

2011-05-23T22:13:55+00:00

This can control an external recording device to log data only during ascent. Signed-off-by: Keith Packard

altos, altosui: Add igniter mode (dual, apogee, main)

2011-05-23T22:13:46+00:00

This provides for redundant charges for either apogee or main. Signed-off-by: Keith Packard

Revert "altos: Debugging TBT issues -- check pin configuration after boot"

2011-05-07T06:55:23+00:00

This reverts commit 514348055630edec12224c4b0964240b929759a3. Looks like this was never a problem.

altos: clear CPU port 1 interrupt flag when handled

2011-05-07T06:12:47+00:00

Signed-off-by: Keith Packard

altos: Hook up the P1 ISR for TeleBT v0.1 bt_link line

2011-05-07T05:59:15+00:00

Otherwise, we're heading off into the weeds... Signed-off-by: Keith Packard

altos: Initialize beeper for telebt

2011-05-07T05:49:54+00:00

Needed to get sounds to come out Signed-off-by: Keith Packard

altos: Debugging TBT issues -- check pin configuration after boot

2011-05-07T05:42:58+00:00

Make sure the serial pins are configured as peripherals Make sure the ser_reset and bt_link pins are going the right direction. Signed-off-by: Keith Packard

altos: Add beeper to TBT v0.1

2011-05-07T05:42:32+00:00

It's available, let's use it. Signed-off-by: Keith Packard

altos: pull TBT v0.1 ser_reset line low

2011-05-07T05:12:31+00:00

This line resets the BT module if held low for three seconds. Signed-off-by: Keith Packard