mjb/altos/src/telemini-v2.0/ao_pins.h, branch 1.3.2.3

altos/telemini-v2.0: Enable beep frequency configuration

2014-05-15T15:30:32+00:00

Now that there's space for this, add it in. Signed-off-by: Keith Packard

altos/cc1111: Switch P1_0 from a green LED to USB pullup

2014-05-15T15:28:30+00:00

Signed-off-by: Keith Packard

altos: Add configurable beep tone

2014-05-02T20:52:45+00:00

This lets you directly set the mid-range beep tone; the high and low tones remain set off of that in the same ratio as before. Note that none of the cc1111 products get this feature as they don't have enough flash space anymore... Signed-off-by: Keith Packard

altos: Report battery voltage instead of S at startup

2014-04-05T07:22:31+00:00

This works on everything with a beeper except TeleMetrum v1.0 which just doesn't have enough flash space for the code. Signed-off-by: Keith Packard

altos: Split EasyMini and TeleMini log formats

2013-08-30T00:22:18+00:00

Same data, but EasyMini uses a 3.0V supply while TeleMini uses 3.3V, which changes the intepretation of all of the ADC values Signed-off-by: Keith Packard

altos: Check for MS5607 MISO low before sleeping

2013-08-27T01:47:27+00:00

If the MISO line goes low before we manage to configure the interrupts, we'll miss it entirely unless we check the pin explicitly. Signed-off-by: Keith Packard

altos: Get telemini to copy current MS5607 state to ring.

2013-08-27T00:15:55+00:00

The ADC code is responsible for actually inserting the non-ADC data into the ring, so do the copy there. Signed-off-by: Keith Packard

cc1111: Rework ADC configuration a bit, fix Tm V2 ADC usage

2013-08-26T23:41:33+00:00

The Tm v2 ADC code was not actually fetching and storing the ADC conversion values. Signed-off-by: Keith Packard

altos/teletiny-v2.0: Support multiple SPI busses on CC1111

2013-08-26T05:24:01+00:00

Needed for TeleMini v2.0 Signed-off-by: Keith Packard

altos: Add exti and spi to telemini-v2.0

2013-08-26T05:24:01+00:00

No longer builds like this Signed-off-by: Keith Packard