mjb/altos/src/telelcotwo-v0.1, branch 1.9

altos/stm: Make beeper driver support all possible tim234 configs

2018-10-19T15:38:32+00:00

And update all users to be explicit about the desired config. Signed-off-by: Keith Packard

altos: Add generic LED driver.

2018-10-13T15:23:25+00:00

This driver uses the generic GPIO functions and allows per-LED port and pin configuration. It supports up to 32 LEDs. Rename SoC-specific LED drivers. Remove enabled parameter to ao_led_init Signed-off-by: Keith Packard

altos: Fix telelcotwo build for new ao_lco_bits.c file

2018-07-04T18:18:12+00:00

Lots of code motion; shouldn't have any functional changes. Signed-off-by: Keith Packard

altos: Require SPI speed to be declared for cc1200

2017-02-20T19:16:52+00:00

The cc1200 can't run SPI faster than 10MHz, so make sure every device picks a SPI clock slower than that. Signed-off-by: Keith Packard

altos: Make telelcotwo control two boxes instead of two pads

2016-08-02T23:55:11+00:00

telefiretwo is now a single pad box, so telelcotwo needs to switch between boxes instead of pads on the same box. Do this by re-purposing the pad arming switches into a box selector and arming switch. Signed-off-by: Keith Packard

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

altos: Use simpler debounce logic for buttons

2016-04-20T03:21:30+00:00

Instead of waiting for a while after the transition to decide if it has stuck, signal the event right away and then ignore other transitions for the debounce interval. This seems to work just as reliably, but has the benefit of eliminating button latency at press time. Signed-off-by: Keith Packard

altos: Add TeleLCOTwo firmware

2016-04-20T03:21:30+00:00

The LCO side of a two-channel launch controller setup. Signed-off-by: Keith Packard