mjb/altos/src/telelcotwo-v0.1, branch 1.8.3AltOS - the operating system for Altus Metrum products
https://git.ethernal.org/mjb/altos/atom?h=1.8.32017-02-20T19:16:52+00:00altos: Require SPI speed to be declared for cc12002017-02-20T19:16:52+00:00Keith Packardkeithp@keithp.com2017-02-19T06:49:34+00:00urn:sha1:1dc31a46f1d1adfdeab444664e581a780d995bf7
The cc1200 can't run SPI faster than 10MHz, so make sure every device
picks a SPI clock slower than that.
Signed-off-by: Keith Packard <keithp@keithp.com>
altos: Make telelcotwo control two boxes instead of two pads2016-08-02T23:55:11+00:00Keith Packardkeithp@keithp.com2016-08-02T23:31:41+00:00urn:sha1:99753673a4a97423300427e276bf550ae5353842
telefiretwo is now a single pad box, so telelcotwo needs to switch
between boxes instead of pads on the same box. Do this by re-purposing
the pad arming switches into a box selector and arming switch.
Signed-off-by: Keith Packard <keithp@keithp.com>
Switch from GPLv2 to GPLv2+2016-07-12T22:41:41+00:00Keith Packardkeithp@keithp.com2016-07-05T16:03:49+00:00urn:sha1:1085ec5d57e0ed5d132f2bbdac1a0b6a32c0ab4a
Signed-off-by: Keith Packard <keithp@keithp.com>
altos: Use simpler debounce logic for buttons2016-04-20T03:21:30+00:00Keith Packardkeithp@keithp.com2015-12-26T04:46:40+00:00urn:sha1:aef5049cf8311927fada922730f85f31c8ddf177
Instead of waiting for a while after the transition to decide if it
has stuck, signal the event right away and then ignore other
transitions for the debounce interval.
This seems to work just as reliably, but has the benefit of
eliminating button latency at press time.
Signed-off-by: Keith Packard <keithp@keithp.com>
altos: Add TeleLCOTwo firmware2016-04-20T03:21:30+00:00Keith Packardkeithp@keithp.com2015-12-22T05:50:43+00:00urn:sha1:11f8ab90d2267715010e652d709beec363f74ed5
The LCO side of a two-channel launch controller setup.
Signed-off-by: Keith Packard <keithp@keithp.com>