mjb/altos/src/telefire-v0.2/ao_pins.h, branch 1.9

altos: Remove cc1111 products

2018-10-13T15:21:58+00:00

We're not testing these anyways; building new firmware for them is not helpful. Signed-off-by: Keith Packard

altos/telefire*: Do voltage tests in decivolts instead of ADC units

2018-06-01T05:39:45+00:00

This requires that each pad device specify the ADC reference voltage and all relevant voltage divider resistor values explicitly so that the ADC values can be converted to decivolts and compared with one another. This should be easier to understand in the future when reading the code. Signed-off-by: Keith Packard

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

altos: Document which TeleFire alarm pins are which

2014-08-15T02:08:19+00:00

Signed-off-by: Keith Packard

altos/telefire,telelco: Add HAS_RADIO_RATE to launch system software

2014-07-13T06:52:05+00:00

This lets us set the rate to a lower value to improve range. 9600 baud works great; 2400 baud makes the initial search take a long time. Signed-off-by: Keith Packard

altos: Call ao_telemetry_reset_interval when telemetry rate changes

2014-07-05T07:38:09+00:00

This lets the radio code adjust the telemetry packet sending pattern when the data rate changes. Signed-off-by: Keith Packard

altos/telefire: Radio status (no data, weak data, good data) on LEDs

2013-06-20T05:45:54+00:00

Instead of blinking RX/TX, report the radio status on the telefire nodes, just like telelco does. This makes the LEDs on telefire *exactly the same* as the LEDs on telelco, which seems like a good idea. Signed-off-by: Keith Packard

altos: Add telefire v0.2 support

2013-06-09T17:00:54+00:00

Signed-off-by: Keith Packard