mjb/altos/src/telebt-v3.0, branch 1.8.4

altos/telebt-v3.0: Add send_packet command

2017-05-20T04:36:01+00:00

Useful for doing host-based RF protocols. Signed-off-by: Keith Packard

altos/telebt-v3.0: Add LCO bits for testing

2017-04-19T23:00:24+00:00

Add the USB commands for LCO testing to TeleBT v3.0 Signed-off-by: Keith Packard

altos: Require SPI speed to be declared for cc1200

2017-02-20T19:16:52+00:00

The cc1200 can't run SPI faster than 10MHz, so make sure every device picks a SPI clock slower than that. Signed-off-by: Keith Packard

altos: Flash all LEDS during power on

2016-08-04T16:54:16+00:00

This tests the LEDS to make sure they all work on the following devices: easymega-v1.0 telebt-v3.0 teledongle-v3.0 telemega-v1.0 telemega-v2.0 telemetrum-v2.0 Signed-off-by: Keith Packard

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

Ignore some built files for 1.6.3

2016-05-07T00:10:14+00:00

Signed-off-by: Keith Packard

altos/telebt-v3.0: Flip CTS/RTS pins for BT module

2016-04-25T22:49:45+00:00

These are wired backwards, so ask that the right pins be used, which requires switching to software control of the pins. Signed-off-by: Keith Packard

altos/telebt-v3.0: Report battery voltage correctly

2015-06-26T01:43:13+00:00

There was an extra %d, and an extra ':' in the output, making the UI not parse the voltage correctly Signed-off-by: Keith Packard

altos: Replace ao_alarm/ao_clear_alarm with ao_sleep_for

2015-02-14T07:51:10+00:00

Having arbitrary alarms firing in the middle of complicated device logic makes no sense at all. Therefore only correct use of ao_alarm and ao_clear_alarm was around a specific ao_sleep call, with correct recovery in case the alarm fires. This patch replaces all uses of ao_alarm/ao_sleep/ao_clear_alarm with ao_sleep_for, a new function which takes the alarm timeout directly. A few cases which weren't simply calling ao_sleep have been reworked to pass the timeout value down to the place where sleep *is* being called, and having that code deal with the return correctly. Signed-off-by: Keith Packard

altos/telebt-v3.0: Set initial radio cal to a sensible value

2015-02-05T04:30:15+00:00

CC1200 uses a different xtal than CC1120, so the default calibration needs to change. This value hit 434.550 on SN 2407, so it seems like a reasonable place to start. Signed-off-by: Keith Packard