mjb/altos/src/stm/ao_serial_stm.c, branch 1.8.2

altos/stmf0: Initialize UART RTS/CTS before turning it on

2017-06-28T06:37:49+00:00

If you try this after the UART is running, it won't work. Signed-off-by: Keith Packard

altos/stm: Interrupt priority is in the upper bits of the priority mask

2017-02-20T20:31:16+00:00

Because the STM32L only offers 16 priority levels, the bottom four bits of each priority mask are not used. All of the interrupt priority settings in the system were using values < 16, making them all effectively the same. Fix that by moving them into the upper 4 bits and using symbolic constants everywhere. Signed-off-by: Keith Packard

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

altos/stm32l: Add support for software-driven HW flow control

2016-04-25T22:48:47+00:00

This allows applications to request that the flow control bits be driven from software rather than hardware, permitting more flexible pin configuration. Signed-off-by: Keith Packard

altos: Use TXE instead of TC for serial on STM32l

2016-04-25T15:49:16+00:00

Using TXE allows for full-speed communication, rather than waiting for each byte to be transmitted before inserting the next into the queue. Signed-off-by: Keith Packard

Debug bits for telebt

2016-04-25T15:47:45+00:00

altos: Replace ao_alarm/ao_clear_alarm with ao_sleep_for

2015-02-14T07:51:10+00:00

Having arbitrary alarms firing in the middle of complicated device logic makes no sense at all. Therefore only correct use of ao_alarm and ao_clear_alarm was around a specific ao_sleep call, with correct recovery in case the alarm fires. This patch replaces all uses of ao_alarm/ao_sleep/ao_clear_alarm with ao_sleep_for, a new function which takes the alarm timeout directly. A few cases which weren't simply calling ao_sleep have been reworked to pass the timeout value down to the place where sleep *is* being called, and having that code deal with the return correctly. Signed-off-by: Keith Packard

altos/stm: Add ability to delay STDIO usage for serial ports

2015-02-01T15:36:51+00:00

Bluetooth needs to delay adding the serial port to stdio until the link is up and running. The cc1111 serial driver had DELAY_SERIAL_*_STDIN bits which have been added to the STM serial driver. Signed-off-by: Keith Packard

altos: Add support for TeleBT v3.0

2015-01-24T19:18:59+00:00

Add support to the BTM driver for non-CC1111 interrupts Add HW flow control to STM serial driver Signed-off-by: Keith Packard

altos: Do not release interrupts from any pollchar function

2013-03-31T19:24:24+00:00

getchar relies on interrupts being blocked across the pollchar calls and into the sleep call or it may go to sleep with data pending. This prefixes all pollchar functions with _ to indicate that they are to be called with interrupts blocked and eliminates all interrupt manipulation calls from within the pollchar functions. Signed-off-by: Keith Packard