mjb/altos/src/stm/ao_serial_stm.c, branch 1.6.3

altos/stm32l: Add support for software-driven HW flow control

2016-04-25T22:48:47+00:00

This allows applications to request that the flow control bits be driven from software rather than hardware, permitting more flexible pin configuration. Signed-off-by: Keith Packard

altos: Use TXE instead of TC for serial on STM32l

2016-04-25T15:49:16+00:00

Using TXE allows for full-speed communication, rather than waiting for each byte to be transmitted before inserting the next into the queue. Signed-off-by: Keith Packard

Debug bits for telebt

2016-04-25T15:47:45+00:00

altos: Replace ao_alarm/ao_clear_alarm with ao_sleep_for

2015-02-14T07:51:10+00:00

Having arbitrary alarms firing in the middle of complicated device logic makes no sense at all. Therefore only correct use of ao_alarm and ao_clear_alarm was around a specific ao_sleep call, with correct recovery in case the alarm fires. This patch replaces all uses of ao_alarm/ao_sleep/ao_clear_alarm with ao_sleep_for, a new function which takes the alarm timeout directly. A few cases which weren't simply calling ao_sleep have been reworked to pass the timeout value down to the place where sleep *is* being called, and having that code deal with the return correctly. Signed-off-by: Keith Packard

altos/stm: Add ability to delay STDIO usage for serial ports

2015-02-01T15:36:51+00:00

Bluetooth needs to delay adding the serial port to stdio until the link is up and running. The cc1111 serial driver had DELAY_SERIAL_*_STDIN bits which have been added to the STM serial driver. Signed-off-by: Keith Packard

altos: Add support for TeleBT v3.0

2015-01-24T19:18:59+00:00

Add support to the BTM driver for non-CC1111 interrupts Add HW flow control to STM serial driver Signed-off-by: Keith Packard

altos: Do not release interrupts from any pollchar function

2013-03-31T19:24:24+00:00

getchar relies on interrupts being blocked across the pollchar calls and into the sleep call or it may go to sleep with data pending. This prefixes all pollchar functions with _ to indicate that they are to be called with interrupts blocked and eliminates all interrupt manipulation calls from within the pollchar functions. Signed-off-by: Keith Packard

altos: Add support for 115200 baud serial rates

2012-12-01T00:03:45+00:00

Necessary for flashing skytraq chips Signed-off-by: Keith Packard

altos: Make stdio 8-bit clean by making pollchar return int

2012-12-01T00:01:07+00:00

We were stealing one value (0xff) in the return value from pollchar to indicate 'not ready yet'. Instead of doing that, use the integer value -1 and have pollchar return an int instead of a char. That necessitated cleaning a few other bits to make sure that 0xff wouldn't get promoted to -1 on accident. Signed-off-by: Keith Packard

altos: Switch drivers to ao_arch_block/release_interrupts

2012-10-25T18:25:42+00:00

Stop using cli/sei, which are avr-specific Signed-off-by: Keith Packard