mjb/altos/src/stm-demo, branch 1.2.9.4

altos: Use installed pdclib

2013-10-10T07:01:26+00:00

Switch over to the installed pdclib everywhere Signed-off-by: Keith Packard

altos: Add debounce helper. Use in button and quadrature drivers for TeleLCO

2013-06-09T19:14:11+00:00

Signed-off-by: Keith Packard

altos: Use flash loader on all STM products

2013-05-08T04:30:26+00:00

Includes the boot chain stuff Signed-off-by: Keith Packard

altos: Create ihx version of stm-demo

2013-05-08T03:16:52+00:00

Both ao-stmload and the eventual java loader will support ihx files. Signed-off-by: Keith Packard

altos: Clean up boot loader support

2013-05-08T03:16:36+00:00

Split out code into separate files. Add support for getting back to boot loader from application. Signed-off-by: Keith Packard

altos: Make stm-flash capable of switching to application

2013-05-08T03:15:43+00:00

This shrinks the base OS load down a bit as well so that stm-flash fits comfortably in the first 8kB of memory. Signed-off-by: Keith Packard

altos: More .gitignore bits

2013-05-08T03:07:54+00:00

stm-demo Signed-off-by: Keith Packard

altos: Call ao_task_init before initializing any drivers

2013-05-08T03:07:52+00:00

When using task queues, the sleep queues must be initialized before any invocation of ao_wakeup or the OS will crash. Just make sure ao_task_init is always invoked early in the task process to get that done. Signed-off-by: Keith Packard

altos: re-enable optimization for stm-demo. remove unused bits

2013-03-10T18:41:49+00:00

This makes stm-demo run on the discovery board again. Signed-off-by: Keith Packard

altos: Set STM GPIO output speed for SPI pins correctly

2013-01-14T04:54:14+00:00

The GPIO pin settings affect the output impedence, and hence the maximum speed for SPI. Cranking these to suitable values allows SPI to run at full speed. Signed-off-by: Keith Packard