mjb/altos/src/micropeak, branch aprs

altos: Log in-flight data for MicroPeak

2012-12-12T19:03:20+00:00

This logs the low 16 bits of the pressure value to the remaining on-chip eeprom. It can be read out with a standard AVR programming dongle. Signed-off-by: Keith Packard

altos: Add load-slow target for MicroPeak

2012-12-12T18:57:03+00:00

This sets the programming clock to 1/4 of the 250kHz clock used by the MicroPeak firmware, allowing the device to be reprogrammed. Signed-off-by: Keith Packard

altos: Tim Van Milligan suggestion for µP -- delay before showing last flight

2012-12-12T07:43:30+00:00

This gives the user time to move their finger out of the way of the LED. Signed-off-by: Keith Packard

altos: Increase MicroPeak blink times a bit

2012-12-11T22:41:53+00:00

make the 0 longer (1 sec now), and make the time between digits longer (also 1 sec now) Signed-off-by: Keith Packard

altos: Use alt_t value to hold displayed height in micropeak

2012-12-10T02:28:33+00:00

Heights are 32 bits (to get .1 meter resolution) in micropeak; make sure we have enough bits while blinking out the computed value. Signed-off-by: Keith Packard

altos: Make sure pa to altitude conversion is done with 32 bits

2012-12-10T02:27:49+00:00

We need 32 bits to hold intermediate values, even if the final altitude is reported in only 16 bits. Signed-off-by: Keith Packard

altos: Store altitude in 32-bits for MicroPeak

2012-12-09T22:32:35+00:00

Needs all 32 bits to store .1 meter resolution Signed-off-by: Keith Packard

altos: Slow down micropeak report timing

2012-11-18T18:36:17+00:00

This makes reading the LED a lot easier. Signed-off-by: Keith Packard

altos: micropeak LED is orange now, not blue

2012-11-18T18:35:39+00:00

Change the names around to match Signed-off-by: Keith Packard

altos/micropeak: Run MS5607 at max resolution for micropeak

2012-10-31T04:31:27+00:00

We've got lots of time, so get the highest resolution baro data available. Signed-off-by: Keith Packard