mjb/altos/src/micropeak, branch android-build-update

altos: Allow ms5607 driver to either set ao_sensor_errors or panic

2019-07-15T20:26:30+00:00

Products that want to remain usable (over USB) after a sensor failure don't want to panic when the ms5607 fails, but products with limited ROM space don't want to have extra code to check for the sensor failure and panic. Change the MS5607 driver to allow either option, and then make the micropeak based devices use it. Signed-off-by: Keith Packard

altos: Move common build definitions to src/Makefile.defs

2019-02-18T21:08:23+00:00

This cleans up the build process for all architectures, providing a common place to specify vpath, cflags and build rules for various common files. Signed-off-by: Keith Packard

altos: Add generic LED driver.

2018-10-13T15:23:25+00:00

This driver uses the generic GPIO functions and allows per-LED port and pin configuration. It supports up to 32 LEDs. Rename SoC-specific LED drivers. Remove enabled parameter to ao_led_init Signed-off-by: Keith Packard

altos/micropeak: Remove all compiler results

2017-12-20T00:57:33+00:00

Not just the current version. Signed-off-by: Keith Packard

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

micropeak: Use fast load mode by default in -load script

2015-05-19T17:23:09+00:00

Speed up flashing in default config Signed-off-by: Keith Packard

altos/micropeak: Add load script template

2014-06-17T06:04:12+00:00

Signed-off-by: Keith Packard

altos/micropeak: Create a script to load firmware.

2014-06-16T22:59:09+00:00

The micropeak-load script flashes micropeak with firmware from whatever directory it is sitting in. A 'publish' target in the source directory copies the script and hex to ~/altusmetrumllc/Binaries Signed-off-by: Keith Packard

altos: Fix nanopeak compile

2014-04-07T05:27:37+00:00

Nanopeak uses port B bit 3 for the LED instead of bit 4. Fix the async code to support arbitrary bits for the serial LED. Signed-off-by: Keith Packard

altos: Provide stable binaries for MicroPeak

2014-04-07T03:14:49+00:00

Publish MicroPeak .hex file to LLC repo and install it from there, rather than rebuilding it locally. This ensures that the installed bits don't depend on local configuration of any kind. Signed-off-by: Keith Packard