mjb/altos/src/micropeak, branch altosui-ms5611

altos/micropeak: Run MS5607 at max resolution for micropeak

2012-10-31T04:31:27+00:00

We've got lots of time, so get the highest resolution baro data available. Signed-off-by: Keith Packard

altos/micropeak: Clock micropeak at 250kHz to save power

2012-10-31T02:41:08+00:00

This reduces average current consumption from 2mA to .4mA. This makes the battery last longer, but also gets the current under something that the typical CR1025 battery can support. Would be nice to reduce current even further; cheap CR1025 batteries still seem to fade a bit at this current level. Signed-off-by: Keith Packard

altos/micropeak: Set boost detect to 10m. Add 30s boost delay.

2012-10-30T00:13:23+00:00

Wait for 30 seconds before even starting look for boost. This provides an opportunity to close up the airframe, potentially causing pressure gradients seen by the baro sensor. Also, require a 10m vertical motion before triggering boost. This should limit accidental boost detect while capturing any actual flights. Signed-off-by: Keith Packard

altos/micropeak: Switch to MS5607 sensor. Require 4m for boost. Elide dead code

2012-10-29T18:47:17+00:00

Signed-off-by: Keith Packard

altos: Add .gitignore for micropeak

2012-10-12T21:27:14+00:00

Signed-off-by: Keith Packard

altos: Add initial micropeak implementation

2012-10-12T21:22:41+00:00

Blinks out max height in decimeters, stores previous flight data to internal eeprom. Signed-off-by: Keith Packard