mjb/altos/src/megametrum-v0.1/ao_pins.h, branch pwmin

altos: Enable ULA-specific options

2012-07-19T20:52:13+00:00

MPU6000 Z-axis for 'up'/'down'. Delay radio by 40 seconds after boost Signed-off-by: Keith Packard

altos: Place STM config values at fixed addresses for re-use

2012-07-17T08:24:52+00:00

Just like cc1111, stick the serial number and radio calibration values at known fixed addresses so that when re-flashing the board, we can go find the existing values. Signed-off-by: Keith Packard

altos/megametrum: Support the four additional pyro channels

2012-07-14T08:29:50+00:00

These use the new pyro code to allow for some flexibility in programming. Signed-off-by: Keith Packard

altos: Move profiling settings to Makefile

2012-07-04T04:02:20+00:00

Instead of splitting the changes across Makefile and ao_pins.h, put them both in Makefile to simplify enabling profiling. Signed-off-by: Keith Packard

altos: Disable mag sensor for megametrum

2012-06-28T06:04:25+00:00

It doesn't work unless USB is connected or occasionally while the debug port is enabled. It's mystic. Signed-off-by: Keith Packard

altos: disable FEC debug on MM

2012-06-27T08:22:32+00:00

Seems to work; we'll leave the code around in case something bad happens later. Signed-off-by: Keith Packard

altos: Clean up usage of port parameters

2012-06-27T06:01:58+00:00

Make stm port parameters always be pointers; this avoids the confusion where some macros took '&port' and others took a bare 'port', and also unifies code to run on other processors in a consistent fashion. Signed-off-by: Keith Packard

altos: Get cc1120 packet reception working

2012-06-25T12:03:34+00:00

Interrupt-per-bit, but it seems to work Signed-off-by: Keith Packard

altos: Add telemetry to megametrum

2012-06-18T02:04:22+00:00

Now that the radio works Signed-off-by: Keith Packard

altos: Start making cc1120 radio work

2012-06-16T05:40:30+00:00

RDF tones and radio calibration work now. Signed-off-by: Keith Packard