mjb/altos/src/lpc/ao_usb_lpc.c, branch debian/1.5-1

altos/lpc: HAS_USB_CONNECT has been changed to mean a custom pin

2014-06-06T04:36:16+00:00

The LPC stuff isn't actually very useful and TeleGPS uses a custom pin instead, and was using HAS_USB_CONNECT to mean the same thing. That wasn't good. Signed-off-by: Keith Packard

altos: Expose ao_usb_running globally

2014-02-18T17:44:52+00:00

This lets other bits of the code know when USB has been connected. Signed-off-by: Keith Packard

altos: Clean up warnings for LPC products

2013-12-21T06:59:35+00:00

Unused varibles, functions and parameters. Signed-off-by: Keith Packard

altos/lpc: Stop sending SETUP IN when the requested size is reached

2013-12-19T08:08:50+00:00

The host won't keep asking for SETUP IN packets once it has received the amount of data requested, so check to see if we've sent that much and flip back to IDLE state if so. Signed-off-by: Keith Packard

altos/lpc: Reset less of the device on USB reset.

2013-12-19T07:27:34+00:00

This leaves most of the device configured across USB reset, which appears to help when sending a IN reply to the first SETUP packet; without this change, the IN reply would always get a length of 0, which is fine for SET_ADDRESS, but not for GET_DESCRIPTOR_DEVICE, which OS X appears to send before setting the address (go figure). Signed-off-by: Keith Packard

altos: Use all 16 bits of setup packet len when limiting reply len

2013-12-18T07:53:59+00:00

We were only using the low 8 bits of the setup packet reply max len, which meant that if the other side sent a weird max len (as Windows 7 does), then we'd truncate our setup reply to whatever was in the low 8 bits of that value. Signed-off-by: Keith Packard

altos/lpc: Add boot loader

2013-06-24T21:30:22+00:00

Support the USB boot loader, add USB pull-up support. Signed-off-by: Keith Packard

altos/lpc: Remove ao_usb_task structure

2013-06-22T07:49:59+00:00

It's not used Signed-off-by: Keith Packard

altos/lpc: Get the IRC turned off after boot time

2013-06-17T21:00:11+00:00

This involved carefully moving the USB away from the IRC before turning it off. Signed-off-by: Keith Packard

altos/lpc: Force idle mode if USB gets an address during boot time

2013-05-20T03:39:19+00:00

This lets EasyMini be booted to idle mode by simply plugging it into USB. Signed-off-by: Keith Packard