mjb/altos/src/lpc/ao_adc_lpc.c, branch debian/1.8.7-2

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

altos/lpc: adc code computes number of active ADC channels

2014-05-21T08:43:12+00:00

Don't require the application to provide AO_NUM_ADC when AO_ADC_NUM is computed automatically. Signed-off-by: Keith Packard

altos: Clean up warnings for LPC products

2013-12-21T06:59:35+00:00

Unused varibles, functions and parameters. Signed-off-by: Keith Packard

altos/lpc: Stop using burst mode for LPC ADC

2013-08-25T23:20:06+00:00

Burst mode doesn't stop after one round of conversions, so we end up getting incorrect values in whatever the last conversion register is. Just use single conversions and take an interrupt per channel. Also, slow down the ADC so that our values are more stable -- just need to make sure we get the whole conversion sequence done 100 times a second. Signed-off-by: Keith Packard

altos/lpc: Get rid of ADC filter

2013-06-17T21:52:32+00:00

Now that the source of the Vcc noise has been identified, remove the unnecessary ADC filtering. Signed-off-by: Keith Packard

altos/lpc: Filter ADC inputs

2013-06-15T08:21:45+00:00

They're amazingly noisy on EasyMini, so just filter them as the only thing we use them for is battery and pyro numbers. Signed-off-by: Keith Packard

altos/lpc: Make ADC inputs work

2013-06-15T08:21:39+00:00

They're still very unstable (bouncing around a lot), but at least they seem to report useful stuff now. Signed-off-by: Keith Packard

altos/lpc: Pull ADC data from the correct registers

2013-05-20T03:39:18+00:00

Was just stepping through register space arbitrarily, which would have worked for EasyMini, but might have failed later if the ADC pin usage wasn't consecutive. Signed-off-by: Keith Packard

altos/lpc: Add ADC driver

2013-05-18T10:18:19+00:00

Uses burst mode to get the whole set of values in one interrupt Signed-off-by: Keith Packard