mjb/altos/src/drivers, branch telemini

altos: Check for MS5607 MISO low before sleeping

2013-08-27T01:47:27+00:00

If the MISO line goes low before we manage to configure the interrupts, we'll miss it entirely unless we check the pin explicitly. Signed-off-by: Keith Packard

altos: Use %ld and %lu for MS5607 debug output

2013-08-27T00:18:17+00:00

The value are 'long', so use the right printf format. Signed-off-by: Keith Packard

altos: Changes required by cc1111 multi-spi support

2013-08-26T05:33:30+00:00

These drivers got missed Signed-off-by: Keith Packard

altos/teletiny-v2.0: Support multiple SPI busses on CC1111

2013-08-26T05:24:01+00:00

Needed for TeleMini v2.0 Signed-off-by: Keith Packard

altos: Make TeleMini v2.0 fit

2013-08-26T05:24:01+00:00

Mash lots of storage locations and code around to shrink stuff down to size Signed-off-by: Keith Packard

Initial TeleMini bits

2013-08-26T05:24:00+00:00

Signed-off-by: Keith Packard

Merge branch 'master' into telegps-v0.3

2013-08-26T05:00:27+00:00

altos: MS5607 pressure computation for low temperatures was wrong

2013-08-26T04:59:47+00:00

Second correction only applies to temps < -15°C, not 15°C. Signed-off-by: Keith Packard

altos: various cc115l driver hacks

2013-08-20T15:54:44+00:00

Try to recover from TX_FIFO_UNDERFLOW by resetting the chip at idle time. Do a calibration phase during setup. Program power to ramp up to limit key down noise. Signed-off-by: Keith Packard

altos: Allow ublox to run at other baud rates

2013-08-17T15:40:33+00:00

Provides a configuration option to set the ublox serial baud rate to something other than 57600 baud Signed-off-by: Keith Packard