mjb/altos/src/drivers, branch debian/1.6.5-1

altos: Use FIFO_THR pin for cc1120 transmit buffering

2016-06-30T02:17:45+00:00

Instead of reading NUM_TXBYTES, set the FIFO_THR pin to indicate when 64 bytes are available in the buffer. Signed-off-by: Keith Packard

altos: cc1200: use FIFO threshold pin output for APRS buffering

2016-06-30T02:17:45+00:00

Instead of polling the device for fifo space, just use the available pin configuration to figure out if there is enough space for a single APRS buffer. Then set the APRS buffer size to match the fifo threshold setting in the chip so that we know we can write the whole APRS buffer once the pin says there's space. Signed-off-by: Keith Packard

altos/drivers: Use more reliable byte interface for CC1120 reception

2016-06-30T02:17:45+00:00

This replaces direct register access with function calls to allow that code to respect the hardware requirements. Signed-off-by: Keith Packard

altos/cc1115l: Reduce trace buffer size

2016-06-10T21:40:26+00:00

A 32-element trace buffer is all the larger we can fit in teledongle. Signed-off-by: Keith Packard

altosuilib: Fill preload map on site or lat/lon change

2016-05-28T03:30:18+00:00

This loads the map view with the selected area when the site entry is changed or the user hits return in the lat/lon fields. This lets you see the target launch site without having to load the whole preload set. Signed-off-by: Keith Packard

altos: Clear packet queue when starting packet master

2016-04-25T22:50:58+00:00

This avoids overfilling the packet buffer when disconnected. Applications using packet mode shouldn't expect that output be saved across master sessions. Signed-off-by: Keith Packard

altos/telelcotwo: Add idle timeout

2016-04-20T03:21:30+00:00

Puts TeleLCOTwo in a low power state (drawing about 80µA) after a timeout (default two minutes) to keep from killing the battery if the device is left turned on. Signed-off-by: Keith Packard

altos: Use simpler debounce logic for buttons

2016-04-20T03:21:30+00:00

Instead of waiting for a while after the transition to decide if it has stuck, signal the event right away and then ignore other transitions for the debounce interval. This seems to work just as reliably, but has the benefit of eliminating button latency at press time. Signed-off-by: Keith Packard

altos: Add ao_lco_two.c; alternate LCO interface code

2016-04-20T03:21:30+00:00

The LCO interface is likely to end up very device specific as the interactions depends on the input devices. Here's a version for TeleLCOTwo, which has two arming switches and a firing button. Signed-off-by: Keith Packard

altos: Allow for pad boxes with different sensor configurations

2016-04-20T03:21:30+00:00

This allows for a pad box without a resistor from power to each FET. That resistor is needed to detect welded relays, but in a solid-state system, that's not a possibility. Signed-off-by: Keith Packard