mjb/altos/src/drivers/ao_pad.c, branch debian/1.6.8-5

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

altos: Allow for pad boxes with different sensor configurations

2016-04-20T03:21:30+00:00

This allows for a pad box without a resistor from power to each FET. That resistor is needed to detect welded relays, but in a solid-state system, that's not a possibility. Signed-off-by: Keith Packard

altos: Add pad support for new telefire versions

2016-04-20T03:21:30+00:00

Makes the voltage divider values configurable, and allows for pyro channels that don't have the resistors necessary to check for a stuck relay. Also supports STM32L processors with wider GPIO registers, and uses the new ao_gpio_set/clr_bits functions to fire igniters rather than cc1111-specific code. Signed-off-by: Keith Packard

altos/telefire: No reply for ARMED. Ignore time for FIRE.

2015-08-29T20:18:46+00:00

This will let us do drag races by letting the LCO arm multiple boxes and fire them all with a single command. Signed-off-by: Keith Packard

telefire: Report telefire battery voltage over telemetry link

2015-05-25T20:23:54+00:00

Signed-off-by: Keith Packard

telefire: Make 'good' RSSI value configurable

2015-05-25T00:27:25+00:00

Different radios will have different 'good' RSSI values, so let each product configure it, leaving the default set to -90dBm, which is a solid signal value for the CC1111. Signed-off-by: Keith Packard

altos/telefire: Add firing length to manual pad command

2014-09-04T05:12:15+00:00

This adds an optional length of time (in 1/10s of a second) to the ao_pad_manual function to enable testing of igniters without needing to use TeleLCO. Signed-off-by: Keith Packard

altos: Clean up trailing whitespace in ao_pad.c

2014-05-09T05:25:12+00:00

Signed-off-by: Keith Packard

altos/telefire: Radio status (no data, weak data, good data) on LEDs

2013-06-20T05:45:54+00:00

Instead of blinking RX/TX, report the radio status on the telefire nodes, just like telelco does. This makes the LEDs on telefire *exactly the same* as the LEDs on telelco, which seems like a good idea. Signed-off-by: Keith Packard

altos/telefire: Leave siren on all the time. Add siren/strobe debugging.

2013-06-09T19:13:39+00:00

The 50% duty cycle wasn't actually loud enough outside. Signed-off-by: Keith Packard