mjb/altos/src/drivers/ao_mma655x.c, branch debian/1.8.1-2

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

altos: Execute self-test on MMA655X part

2013-12-21T06:04:53+00:00

This doesn't check for fine calibration, just makes sure the part is within the broad tolerances specified by the manufacturer. The subtle fix here was actually getting reset working -- there was a typo in the bitpattern definition which caused the reset to fail, making it hard to self-test the part, as self-test is only valid before the part is running. Signed-off-by: Keith Packard

altos: Remove some MMA655x debugging printfs

2013-05-16T05:13:08+00:00

Signed-off-by: Keith Packard

altos: Fix up ms5607 and mma655x commands to work again

2012-10-09T06:24:19+00:00

These just display the most recently fetched values Signed-off-by: Keith Packard

altos: Go back to recording sensor data in globals

2012-10-09T06:04:16+00:00

Instead of trying to get things into the ring from a variety of functions, go back to the simpler method of storing them in globals and having the ADC code just pluck out the most recent values. Signed-off-by: Keith Packard

altos: Re-enable the ms5607 and mma655x acquisition threads

2012-10-03T17:43:28+00:00

These were disabled to help with testing in Argonia Signed-off-by: Keith Packard

altos: Get mma655x driver limping along

2012-09-01T03:19:40+00:00

This appears to drive the chip correctly to see values from the accelerometer. Signed-off-by: Keith Packard

altos: Trigger sample complete when all data are ready

2012-08-26T16:53:16+00:00

This has each sensor mark a bit in the current data record which is then sent for processing when all of the data are present. Signed-off-by: Keith Packard

altos: Add MMA655X driver

2012-08-19T04:26:34+00:00

Just debug code at this point, will complete on real hardware Signed-off-by: Keith Packard