mjb/altos/src/drivers/ao_cc1120.h, branch 1.3.1

altos: Generate unmodulated carrier for CC1120 test mode

2013-05-16T05:13:08+00:00

This sets the deviation to 0, enables the preamble and turns on the transmitter. It will sit there happily sending a bare carrier forever Signed-off-by: Keith Packard

altos: Reconfigure CC1120 receiver to match our usage

2013-05-08T03:07:54+00:00

Open up the AGC to the full range. Set the AGC ref based on our receive BW (100kHz). Signed-off-by: Keith Packard

altos: Optimize FEC encode and decode

2012-06-27T06:11:10+00:00

Integrate interleaving, CRC and padding within the decode/encode functions. Provide for ISR priorities so that the 1120 RX interrupt takes precedence over the other interrupts or we risk losing bits. Optimize the viterbi decoder a bit (goes from 10ms per packet to 7ms per packet). Signed-off-by: Keith Packard

altos: Start making cc1120 radio work

2012-06-16T05:40:30+00:00

RDF tones and radio calibration work now. Signed-off-by: Keith Packard

altos: Hacking at cc1120 driver

2012-05-08T04:52:12+00:00

Still doesn't work, but this adds a ton more register definitions Signed-off-by: Keith Packard

altos: Starting to write cc1120 driver

2012-04-17T18:01:18+00:00

This does "something" in radio test mode, appearing to generate a 730MHz signal. Signed-off-by: Keith Packard