mjb/altos/src/core/ao.h, branch altosdroid_v1.2-1

altoslib/altosui: Carry receiver status around in AltosListenerState

2013-04-09T07:30:36+00:00

This moves the crc_errors into the new structure and adds a receiver battery voltage value there as well. Now the receiver status can be monitored separately from the flight status. That also means that code receiving state updates should be prepared to accept missing listener or flight state values. Signed-off-by: Keith Packard

altos: Do not release interrupts from any pollchar function

2013-03-31T19:24:24+00:00

getchar relies on interrupts being blocked across the pollchar calls and into the sleep call or it may go to sleep with data pending. This prefixes all pollchar functions with _ to indicate that they are to be called with interrupts blocked and eliminates all interrupt manipulation calls from within the pollchar functions. Signed-off-by: Keith Packard

altos: Get CC115L radio working.

2013-03-30T00:05:36+00:00

This involved figuring out which GPIO signal would reliably indicate that the transmitter was finished; I ended up using the PA_PD bit for this. This also converts all of the radio users to the long packet support as the CC115L has only a 64-byte fifo, not large enough to hold either an RDF tone or a regular AltOS telemetry packet. This also renames the public API for sending APRS packets from ao_radio_send_lots to ao_radio_send_aprs, which is at least more accurate. The workings of that API haven't changed, just the name. Signed-off-by: Keith Packard

altos: Add temporary RF power settings

2013-03-29T19:13:59+00:00

These expose the raw cc115l and rfpa0133 register settings so that we can calibrate them against measured power outputs. I've tested them to verify that they change how much power the board consumes, so they're clearly doing something... Signed-off-by: Keith Packard

altos: Add new panic flag for bufio misuse

2013-03-27T08:15:04+00:00

Allow the bufio code to signal a fatal error if someone misuses the API Signed-off-by: Keith Packard

altos: Allow radio recv and xmit to be separately configured

2013-03-26T21:27:46+00:00

The CC115L is xmit only, so split out the functions and provide defines to check for xmit or recv separately as needed. Signed-off-by: Keith Packard

altos: Add RFPA0133 amplifier driver

2013-03-26T21:24:45+00:00

No configuration of power level yet, just the bare driver. Signed-off-by: Keith Packard

Update avr ao_spi_slave code to match API changes

2013-01-13T18:32:52+00:00

Made the interface use void * for pointers and uint16_t for lengths Signed-off-by: Keith Packard

altos: Make APRS interval configurable

2012-12-08T01:18:32+00:00

This provides a separate configuration value for APRS, allowing the interval between APRS reports to vary. Signed-off-by: Keith Packard

altos: Allow telemetry, rdf and APRS to be individually controlled

2012-12-06T18:28:14+00:00

But, only when APRS is available so that TeleMetrum and TeleMini don't change behaviour Signed-off-by: Keith Packard