mjb/altos/src/cc1111, branch pwmin

altos: Baro-only (but record accel) for TM v1.2

2012-07-22T05:18:35+00:00

Changes for ULA payload Signed-off-by: Keith Packard

altos: Place STM config values at fixed addresses for re-use

2012-07-17T08:24:52+00:00

Just like cc1111, stick the serial number and radio calibration values at known fixed addresses so that when re-flashing the board, we can go find the existing values. Signed-off-by: Keith Packard

altos: Make ao_tick_count visible

2012-07-16T22:24:21+00:00

Necessary to fetch it when interrupts are already disabled as we can't call ao_time then. Signed-off-by: Keith Packard

src: Add explicit 'pin' argument to ao_enable_output

2012-07-14T09:44:17+00:00

This lets the cc1111 use the atomic bit operation instead of a mask, which is immune to interrupt issues as well as being a shorter code sequence. Signed-off-by: Keith Packard

altos: Have 'make clean' remove all programs, even old ones

2012-07-11T20:49:26+00:00

This makes sure that changing version numbers doesn't leave old compiled output lying around. Signed-off-by: Keith Packard

altos: Force 434.550Mhz by connecting debug gnd and clk (trac #41)

2012-07-11T05:41:59+00:00

Check for pin P2_2 low at startup and set the frequency to 434.550MHz. This value won't get written to flash, so rebooting again will restore the configured frequency. Signed-off-by: Keith Packard

altos: Signal continuity over radio in pad mode (trac #40)

2012-07-11T03:35:19+00:00

This is especially useful for telemini which has no beeper, allowing you to hear the continuity signal while at the pad over the air. Signed-off-by: Keith Packard

altos: Declare cc1111 accel_ref as unsigned so the math works

2012-06-29T00:43:36+00:00

If accel_ref is signed, then the careful shifting and dividing dance necessary to correct for changes in the relationship between the 5V and 3.3V supplies always generates zero. Signed-off-by: Keith Packard

altos: include targe SPI speed in get request

2012-06-27T21:34:53+00:00

STM needs it to be provided when enabling the SPI device, so just fix AVR and cc1111 to do the same. Signed-off-by: Keith Packard

altos: ao_ignite.c is no longer cc1111 specific

2012-06-27T06:26:32+00:00

Move it to core Signed-off-by: Keith Packard