mjb/altos/src/cc1111, branch accel-cal-ui

altos: Make CDC ACM 'line coding' public

2017-05-05T05:10:36+00:00

This allows other systems to see what baud rate the host has requested. Signed-off-by: Keith Packard

altos: Move old AO_LAUNCH defines to cc1111/ao_launch.h

2017-04-23T06:04:12+00:00

These were getting accidentally used by ao_pad.c Signed-off-by: Keith Packard

altos/cc1111: Remove unneeded initialization in ao_timer.c

2017-02-20T19:22:21+00:00

The timers are all stopped when the chip boots, so no need to stop them. This saves some text space, allowing the current code to (just barely) fit. Signed-off-by: Keith Packard

altos: Expose cc1200 radio test functions for telemini bringup

2016-07-27T20:24:57+00:00

This exposes the cc1200 radio test function so we can load special test firmware in telemini to do the radio cal as it has no USB to perform that interactively. Signed-off-by: Keith Packard

Switch from GPLv2 to GPLv2+

2016-07-12T22:41:41+00:00

Signed-off-by: Keith Packard

altos/cc1111: Remove 'show tasks' command

2016-07-01T03:43:03+00:00

This saves space on cc1111 parts. Signed-off-by: Keith Packard

altos/cc1111: Use SW to drive UART RTS pin

2016-05-09T18:33:48+00:00

Can't get the hw to work. Signed-off-by: Keith Packard

altos: Add ao_gpi_set/clr_bits functions

2016-04-13T13:17:06+00:00

These set or clear a group of bits in a single GPIO register all together. Signed-off-by: Keith Packard

altos: Replace ao_alarm/ao_clear_alarm with ao_sleep_for

2015-02-14T07:51:10+00:00

Having arbitrary alarms firing in the middle of complicated device logic makes no sense at all. Therefore only correct use of ao_alarm and ao_clear_alarm was around a specific ao_sleep call, with correct recovery in case the alarm fires. This patch replaces all uses of ao_alarm/ao_sleep/ao_clear_alarm with ao_sleep_for, a new function which takes the alarm timeout directly. A few cases which weren't simply calling ao_sleep have been reworked to pass the timeout value down to the place where sleep *is* being called, and having that code deal with the return correctly. Signed-off-by: Keith Packard

altos: Declare port register type only in arch header

2014-11-06T23:58:42+00:00

Instead of defaulting to 8 bits, explicitly require declaration of the type of the port register for each architecture. Signed-off-by: Keith Packard