mjb/altos/src/cc1111/ao_pins.h, branch telegps-hacks

altos/cc1111: Errata fix isn't needed for discontinued products

2014-05-14T05:46:19+00:00

And, doesn't fit in memory for some of them, so don't compile it. Signed-off-by: Keith Packard

altos: Add configurable beep tone

2014-05-02T20:52:45+00:00

This lets you directly set the mid-range beep tone; the high and low tones remain set off of that in the same ratio as before. Note that none of the cc1111 products get this feature as they don't have enough flash space anymore... Signed-off-by: Keith Packard

altos: Report battery voltage instead of S at startup

2014-04-05T07:22:31+00:00

This works on everything with a beeper except TeleMetrum v1.0 which just doesn't have enough flash space for the code. Signed-off-by: Keith Packard

altos: Add telefire-v0.1

2012-07-30T02:47:42+00:00

Signed-off-by: Keith Packard

altos: Force 434.550Mhz by connecting debug gnd and clk (trac #41)

2012-07-11T05:41:59+00:00

Check for pin P2_2 low at startup and set the frequency to 434.550MHz. This value won't get written to flash, so rebooting again will restore the configured frequency. Signed-off-by: Keith Packard

altos: Clean up usage of port parameters

2012-06-27T06:01:58+00:00

Make stm port parameters always be pointers; this avoids the confusion where some macros took '&port' and others took a bare 'port', and also unifies code to run on other processors in a consistent fashion. Signed-off-by: Keith Packard

altos: Remove unused AES code from teledongle and tidongle

2012-06-05T03:49:15+00:00

Leave this out as neither of these products need it. Signed-off-by: Keith Packard

altos: All cc1111 products have a radio

2012-05-28T17:45:30+00:00

Signed-off-by: Keith Packard

altos: Massive product config cleanup

2012-04-14T21:04:29+00:00

Support multiple serial ports more cleanly Split out parts of ao.h into separate feature header files Signed-off-by: Keith Packard

altos: Add support for multiple SPI busses and sharing device drivers

2012-04-14T20:21:09+00:00

The STM32L151 has several SPI busses, and we want to use more than one, so add a 'bus' parameter to the SPI interfaces. To avoid wasting time on AVR and CC1111 processors which only use one SPI bus, elide those parameters from the actual functions by wrapping them with macros. Configuring chip select is now all macroized so that each chip can have its own version, allowing the STM to share the various SPI device drivers with the cc1111 and avr processors. Note that only the M25 driver has been ported; porting the others is 'trivial', but not necessary at this point. Signed-off-by: Keith Packard