mjb/altos/src/cc1111/ao_pins.h, branch 1.4.9.1

altos: Rework packet receive for cc1120

2014-07-05T07:38:10+00:00

Instead of blocking on PQT, just set up the receiver to start going and when the first bit interrupt comes in, grab the SPI bus if possible and configure it for reception. This improves sensitivity in the radio by a significant amount while making the code conceptually a bit nicer. Signed-off-by: Keith Packard

altos/cc1111: Add 2400 and 9600 baud telemetry rate support

2014-07-05T07:38:10+00:00

Signed-off-by: Keith Packard

altos/cc1111: Adjust receive parameters to improve sensitivity

2014-07-05T07:38:10+00:00

This removes the packet quality test and carrier sense tests when deciding whether to start decoding a packet. This lets more bad packets through, but the CRC check catches those and now we're regularly receiving packets down to -110 or even -112 dBm. Before this change, we'd rarely see packets as low as -105dBm Signed-off-by: Keith Packard

altos: Call ao_telemetry_reset_interval when telemetry rate changes

2014-07-05T07:38:09+00:00

This lets the radio code adjust the telemetry packet sending pattern when the data rate changes. Signed-off-by: Keith Packard

altos: Report total available log space in version command

2014-06-10T16:38:53+00:00

This provides a more accurate means of determining available log space than guessing whether some portion of the flash chip holds configuration data. Signed-off-by: Keith Packard

altos/cc1111: Errata fix isn't needed for discontinued products

2014-05-14T05:46:19+00:00

And, doesn't fit in memory for some of them, so don't compile it. Signed-off-by: Keith Packard

altos: Add configurable beep tone

2014-05-02T20:52:45+00:00

This lets you directly set the mid-range beep tone; the high and low tones remain set off of that in the same ratio as before. Note that none of the cc1111 products get this feature as they don't have enough flash space anymore... Signed-off-by: Keith Packard

altos: Report battery voltage instead of S at startup

2014-04-05T07:22:31+00:00

This works on everything with a beeper except TeleMetrum v1.0 which just doesn't have enough flash space for the code. Signed-off-by: Keith Packard

altos: Add telefire-v0.1

2012-07-30T02:47:42+00:00

Signed-off-by: Keith Packard

altos: Force 434.550Mhz by connecting debug gnd and clk (trac #41)

2012-07-11T05:41:59+00:00

Check for pin P2_2 low at startup and set the frequency to 434.550MHz. This value won't get written to flash, so rebooting again will restore the configured frequency. Signed-off-by: Keith Packard