mjb/altos/src/ao_telemetrum.c, branch debian/0.8

Change altos build process to support per-product compile-time changes

2010-02-21T04:30:27+00:00

This creates per-product subdirectories and recompiles everything for each product, allowing per-product compile-time changes for things like peripheral pin assignments and attached serial devices. Signed-off-by: Keith Packard

Force idle mode by shorting the SPI clock to ground at boot time.

2010-01-10T06:06:19+00:00

This allows you to override the flight mode detection code in case the accelerometer calibration is broken somehow. Hold the SPI clock shoted to ground until the LED comes on, then remove it. Signed-off-by: Keith Packard

Remove green LED and temp sensor from v0.2 code

2010-01-09T09:29:41+00:00

Signed-off-by: Keith Packard

Disable monitor mode before attempting radio test.

2009-12-19T22:14:40+00:00

If monitor mode is left active, then the radio lock will not be able to be acquired for the radio test. Signed-off-by: Keith Packard

Enable packet-based communcation to command processor

2009-11-02T04:57:03+00:00

This splits the packet code into master/slave halves and hooks the slave side up to the getchar/putchar/flush logic in ao_stdio.c Signed-off-by: Keith Packard

Initial packet bits. Just testing transmission

2009-10-30T23:39:15+00:00

Remove bit-banging debug support from TM board builds

2009-09-03T05:01:52+00:00

Our current TM boards don't have the wires to do bit-banging to another cc1111 board, so it doesn't make sense to fill up their flash with useless code (and the 'help' text with useless commands). Leave this to the TI board until we have boards that can serve as debug dongles. Signed-off-by: Keith Packard

Fix clock initialization to not try to use 32kHz xtal on P2_3/P2_4

2009-06-17T20:55:23+00:00

None of our boards have a 32kHz xtal oscillator, instead we use those pins (on Telemetrum) for the deployment firing circuits. The old clock initialization code was switching from the 32kHz RC oscillator to the 32kHz crystal and overriding our use of those pins. Signed-off-by: Keith Packard

Use autotools, move altos to src subdir

2009-06-04T17:41:34+00:00

Signed-off-by: Keith Packard