mjb/altos/src/ao_pins.h, branch 0.9.4.3

altos: Add beeper to TBT v0.1

2011-05-07T05:42:32+00:00

It's available, let's use it. Signed-off-by: Keith Packard

altos: Fix BT link status pin for real TBT hardware

2011-05-07T04:13:19+00:00

The prototype used P2_1, while the real hardware uses P1_7. Lots of defines to make this work... Signed-off-by: Keith Packard

altos: Use USART configuration 1 with flow control for TBT

2011-05-07T03:35:03+00:00

It's just wired that way. Signed-off-by: Keith Packard

altos: Add preliminary telebt v0.1 defines

2011-05-06T22:44:56+00:00

This should make the telebt v0.1 binary that works on the real hardware. Signed-off-by: Keith Packard

Merge branch 'telemini' into telebt

2011-04-19T21:06:39+00:00

altosui: Eliminate ao_cmd_filter hook

2011-04-19T21:01:19+00:00

Disabling status messages means we don't need to filter them out of the input stream. Signed-off-by: Keith Packard

altos: Write a few pre-launch samples for Tm/Tn devices

2011-04-14T16:38:48+00:00

Record pre-launch samples in a small ring and flush that to flash when launch is detected. This provides a complete record of the flight, rather than simply starting after launch detect. Signed-off-by: Keith Packard

altos: Use PIO(6) on BTM to monitor BT connection. Fix BTM init.

2011-04-08T05:00:38+00:00

PIo(6) appears to be an active-low indication of the Bluetooth connection status. Hook this up using an interrupt to track the link state instead of using in-band status messages. Signed-off-by: Keith Packard

altos: Clean up BT serial communcations

2011-04-02T00:26:08+00:00

Disable echo on both ends in command mode to eliminate looping error values. Switch to 57600 baud to improve performance. Signed-off-by: Keith Packard

altos: Add initial TeleBT code

2011-04-01T03:59:07+00:00

Prototyping with a TeleMetrum v0.1 board and a serial link to a bluetooth module. Signed-off-by: Keith Packard