mjb/altos/ao-tools/ao-stmload, branch droid-gps

ao-tools/ao-stmload: Be smarter about ELF parsing. Retry open on failure.

2013-03-31T19:42:37+00:00

Figuring out what goes where is tricky; turns out we want to pull all of the sections that map inside any program area that is supposed to be loaded from the file. So, we walk the program headers, then walk all of the section headers looking for those that suck data from the same portion of the file. Compute where in ROM each relevant section goes and build a full ROM image in memory using that. This patch also adds code to close and re-open the device if the first open failed to do what we want. Much nicer to have the computer figure out when the open succeeded rather than having people re-run the app. Signed-off-by: Keith Packard

altos: Add a bunch of .gitignore entries

2012-08-30T21:22:51+00:00

Clean up the git status output Signed-off-by: Keith Packard

ao-stmload: Always round up load amount to 4 byte boundary

2012-08-29T06:00:22+00:00

The flashing code doesn't deal with partial writes. Signed-off-by: Keith Packard

Don't build ao-stmload if stlink is not available.

2012-07-31T08:04:34+00:00

Signed-off-by: Mike Beattie

tools: Use pkgconfig to find stlink for ao-stmload

2012-07-20T19:04:52+00:00

Signed-off-by: Keith Packard

Add ao-stmload tool

2012-07-17T08:18:45+00:00

This loads an ELF image through the STlink programming interface using the stlink utility library Signed-off-by: Keith Packard