mjb/altos/altosui, branch with-pdclib

altosui: Hide non-applicable altimeter config values

2013-12-18T10:03:15+00:00

This makes configuring EasyMini a lot easier... Signed-off-by: Keith Packard

altoslib: Pass InterruptedException up the stack instead of hiding it

2013-12-18T09:14:11+00:00

When interrupting a thread that is talking to a serial device, it's important not to have that thread discard the InterruptedException so that it will actually terminate. This patch removes a bunch of places that were discarding InterruptedExceptions and lets higher level code see them so that they can exit cleanly. Signed-off-by: Keith Packard

altosui: Add EasyMini bits to fat distribution images. Update telemetrum.inf

2013-12-18T06:53:45+00:00

Signed-off-by: Keith Packard

java: Add -target 1.6 to all java compiles

2013-12-10T08:51:01+00:00

This makes sure the results can run with the old JVM Signed-off-by: Keith Packard

altosui: Ship TeleMega-v1.0 firmware

2013-12-10T07:14:55+00:00

Signed-off-by: Keith Packard

altosui: When flashing to TeleDongle or TeleBT, match any .ihx file

2013-12-09T05:07:17+00:00

Let the user pick any .ihx file when using a device which can only be used as a pair programmer. Note that 'telemetrum' can be either, and we'll assume that it's a self-programmed device (v2) for now. Signed-off-by: Keith Packard

altosui: Match directories in hex file matcher

2013-12-09T04:34:11+00:00

This makes it possible to navigate around the file system Signed-off-by: Keith Packard

altoslib: Add self-flashing code

2013-12-09T04:09:10+00:00

This adds the ability to use the AltOS flash-loader on both STM and NXP processors. Signed-off-by: Keith Packard

altoslib: Support binary reading/writing in AltosLink

2013-12-09T03:44:49+00:00

Binary reads require an explicit length, and do not work while telemetry is running. Signed-off-by: Keith Packard

altosui: Clean up serial close handling

2013-12-07T17:53:10+00:00

Unify serial close processing in a single function (close_serial), make everyone else call that. This avoids a couple of cases where the device would be closed and not removed from the devices_opened list, leading to 'device is already in use' messages. Signed-off-by: Keith Packard