mjb/altos, branch 0.9.4

Switch version to 0.9.4

2011-05-26T03:38:02+00:00

For Mayhem, so we can tell what version each board is running Signed-off-by: Keith Packard

Revert "altos: Debugging TBT issues -- check pin configuration after boot"

2011-05-07T06:55:23+00:00

This reverts commit 514348055630edec12224c4b0964240b929759a3. Looks like this was never a problem.

altos: clear CPU port 1 interrupt flag when handled

2011-05-07T06:12:47+00:00

Signed-off-by: Keith Packard

altos: Hook up the P1 ISR for TeleBT v0.1 bt_link line

2011-05-07T05:59:15+00:00

Otherwise, we're heading off into the weeds... Signed-off-by: Keith Packard

altos: Initialize beeper for telebt

2011-05-07T05:49:54+00:00

Needed to get sounds to come out Signed-off-by: Keith Packard

altos: Debugging TBT issues -- check pin configuration after boot

2011-05-07T05:42:58+00:00

Make sure the serial pins are configured as peripherals Make sure the ser_reset and bt_link pins are going the right direction. Signed-off-by: Keith Packard

altos: Add beeper to TBT v0.1

2011-05-07T05:42:32+00:00

It's available, let's use it. Signed-off-by: Keith Packard

altos: pull TBT v0.1 ser_reset line low

2011-05-07T05:12:31+00:00

This line resets the BT module if held low for three seconds. Signed-off-by: Keith Packard

altos: Fix BT link status pin for real TBT hardware

2011-05-07T04:13:19+00:00

The prototype used P2_1, while the real hardware uses P1_7. Lots of defines to make this work... Signed-off-by: Keith Packard

altos: Use USART configuration 1 with flow control for TBT

2011-05-07T03:35:03+00:00

It's just wired that way. Signed-off-by: Keith Packard